Ominaisuudet
- Case Type:
Fired
- Patruuna:
45 (Long) Colt
- Toimituksen paino: 0,091kg
- Toimituksen korkeus: 28mm
- Toimituksen leveys: 30mm
- Toimituksen pituus: 53mm
- UPC: 815145022912
Tuotenro: 749002528
Valm.nro: PH-45C
815145022912 Wilson Case Holders pitävät patruunan suoraan leikkurin pinnan suhteen, mikä mahdollistaa trimmaamisen sekä sisäisen kaulan reamingin, patruunan suun burrin poistamisen ja sotilaspuristuksen poistamisen. Standardit Pistol Case Holders vaativat, että patruunat naputellaan tiukasti pidikkeeseen, jotta ne pysyvät turvallisesti paikallaan suoran seinärakenteen vuoksi. Suosittelemme Q-Style case holdereita, kun niitä on saatavilla pistoolipatruunoille.Toimitusaika noin 2-4 viikkoa.
Wilson Case Holders pitävät patruunapussin suorana leikkurin pinnan suhteen, mikä mahdollistaa tarkat trimmausprosessit, sekä sisäisen kaulan reamingin, patruunasuun deburringin ja sotilaskrimppien poistamisen.
Valitse Wilson Trimmer Case Holders ja varmista, että ammuntasi on tarkkaa ja luotettavaa!
Fired
45 (Long) Colt
Used to make Makarov Brass 27.6.2015
I used this Wilson holder to turn 9mm luger into 9mm Makarov. Used a drill to speed things up. Obviously, you size to Makarov after you trim to about 18mm (exact trim to length in your load book).
Works great. Creates a mess of course. I had to create a system where I would hammer out the piece of brass by using a brass punch. One quick tap to the holder would knock it out. It's not like the rifle brass which can be knocked out quickly. Wilson warns of this in the instructions with this holder.
Works when it is used correctly 30.4.2015
I have accurately cut many cases using this without using a press. As long as the back of the cartridge extends out of the holder to where the micro-meters foot can make contact with it and the cutting bit can make contact with the case edge you are golden. This will make a consistent cut time after time as it is a set distance based on the cartridge. if the cartridge does not extend out the back of the holder your micro-meter foot will contact the holder and will cut the case too short. My only gripe is that the holder has a tenancy to spin in the trimmer when the cutter is pressed harder to cut faster.
Kohdattiin virhe tämän sisällön lataamisessa. Päivitä sivu jatkaaksesi. Jos ongelma jatkuu, ota yhteyttä asiakaspalveluumme.