Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation.
Vortex Viper/Venom sight mount S&W K, L, N, X Frame revolvereille
EGW:n sight mount on täydellinen lisävaruste S&W K, L, N ja X Frame revolvereille. Tämä mount mahdollistaa Vortex Viper/Venom, Burris FastFire tai Docter punapisteen kiinnittämisen aseeseesi helposti ja nopeasti.
Asennusohjeet
- Poista takasight*
- Asenna EGW Sight Mount dovetailiin
- Kireä set screw (jos sovellettavissa)
- Aseta punapistesuuntain EGW Sight Mountille (pienellä paperinpalan asettaminen punapistesuuntain ja sight mountin väliin helpottaa poistamista ja pitää Loctite:n punapistesuuntain ulkopuolella).
- Käytä sinistä Loctite:a mukana toimitettuihin kiinnityspultteihin
- Kireä kiinnityspultit 15in/lbs
Toimitukseen sisältyy:
- 2 Button Head Cap Screws - Vortex Viper ja Venom Sightteihin
- 2 Flat Head Cap Screws - Burris FastFire ja Docter Sightteihin
Asennukseen tarvitaan 5/64'' allen avain.