Ominaisuudet
- Toimituksen paino: 0,045kg
- Toimituksen korkeus: 13mm
- Toimituksen leveys: 76mm
- Toimituksen pituus: 254mm
- UPC: 050806023253
Tuotenro: 587036968
Valm.nro: 36968
050806023253 Alun perin suunniteltu metallityöntekijöille ja mekaanikolle jumittuneiden pulttien poistamiseen, nämä raskaat poisto työkalut puristuvat metalliin tarjoten lisäpidon, jotta voit käyttää tarvittavaa voimaa poistaaksesi tukkeutuneen supistimen, joka ei liiku tavallisilla työkaluilla. Saatavilla 12 ja 20 gauge -kokoisina. Täydelliset ohjeet mukana. Varovaisuus: suun vaurioita voi syntyä, jos käytetään väärin.Jälkitilaus, toimitusaika n. 4-12 viikkoa USA:n varastosta.
Alun perin suunniteltu metallityöläisille ja mekaanikolle jumiutuneiden pulttien poistamiseen, tämä kestävä extractor puristuu metalliin lisäpidon saamiseksi, jotta voit kohdistaa tarvittavan voiman supistajan poistamiseen, joka ei liikahda tavallisilla työkaluilla. Saatavana 12 ja 20 kaliiperin malleissa. Täydelliset käyttöohjeet sisältyvät pakkaukseen. Varovaisuus: suun vaurioita voi tapahtua, jos käytetään väärin.
Didn't work 12.8.2014
I tried to remove a stuck choke tube from a Bennelli shotgun with no luck at all. I had previously talked with a Brownell's consultant and was told to follow the written instructions that came with the tool. I did that to the letter. The cutting edges of the tool were softer than the choke tube metal and merely broke away as I tried to twist the tool.
I finally had to try another method of removal which I found on Youtube. I used JB Weld to glue in a deep well socket that was about 1/8 of an inch smaller in diameter than the choke tube. After letting it set up for 24 hours I used a ratchet to remove the socket which bonded to the choke tube.
I would return the tool to Brownells except that postage would cost as much as the tool.
Worked well 2.4.2014
I had an inventor DS choke tube stuck in an A5 thats about a year old. Tried everything to get the choke out to the point where wrenches wore the notches on the tube.
I bought this tool as a hail mary before relenting and going to a gunsmith. It took a couple tries and tapping the tool in harder, but with a crescent wrench and a couple sharp raps with a hammer to the tool was finally able to get the tube out. No damage to barrel, choke was not any more messed than before, junking it though.
You might have drive the tool in a little harder than you think.
Good price shipping was good, fedex is always good.
Kohdattiin virhe tämän sisällön lataamisessa. Päivitä sivu jatkaaksesi. Jos ongelma jatkuu, ota yhteyttä asiakaspalveluumme.