Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Laadukas kiinnike Trijicon RMR -punapisteelle
SPRINGFIELD XD TRIJICON RMR SIGHT MOUNT on erinomainen valinta, jos haluat parantaa tarkkuuttasi ja nopeutta ampuma-asemassasi. Tämä kiinnike on suunniteltu erityisesti Trijicon RMR -punapisteelle ja se on valmistettu kestävästä 7075-alumiinista.
Tuotteen tiedot:
- Materiaali: 7075 alumiini
- Päällyste: Matte Black Hardcoat
- Kokonaispituus: 1.780"
- Kokonaisleveys: 1.1"
- Kiinnitysruuvit: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
- Yhteensopivuus: Trijicon RMR, Holosun HS507C
Yhteensopivat aseet:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Ei yhteensopiva:
Asennus on helppoa: Poista vain takasuunta ja vaihda se kiinnikkeeseemme, jolloin voit asentaa Trijicon RMR -punapisteen. Muutoksia aseeseen ei tarvita, ja voit aina poistaa kiinnikkeen ja palauttaa takasuuntaasi.
Asennusohjeet:
- Poista takasuunta*
- Asenna EGW Sight Mount kiskoon
- Kiristä set screw (tarvittaessa)
- Aseta punapiste EGW Sight Mountiin (pienellä paperinpalan käytöllä punapisteen ja kiinnikkeen välissä helpotat sen poistamista ja pidät Loctitea poissa punapisteestä)
- Käytä sinistä Loctitea mukana tuleville kiinnitysruuveille
- Kiristä kiinnitysruuvit 15 in/lbs
Huom: Tämä kiinnike vaatii 5/64'' allen-avainruuvien asennukseen.