A full-length sizing die is designed to resize the entire length of the cartridge case, not just the neck. Unlike neck-sizing dies, which only resize the neck portion, full-length sizing dies are versatile and suitable for any rifle chambered in the same cartridge. When you fire a cartridge, the brass case expands to fit the chamber of your rifle. After firing, the case contracts slightly, but it may not return to its original dimensions. The full-length sizing die restores the case to the correct dimensions by resizing both the neck and body. It also removes any bulges or irregularities caused during firing. Setting up a full-length sizing die involves several steps: Clean the outside of the fired cases with alcohol and a cloth. Zero out the calipers using a headspace comparator and a fired case. Install the full-length sizing die and adjust it gradually until the case shoulder is bumped back by 0.001 inch. Lock the die and lubricate the cases before sizing them. Check the shoulder bump every 10 cases or so and adjust the die if needed. Avoid overworking the brass to prevent case head separation.
Täydellinen ratkaisu patruunoiden koon säätämiseen
RIFLE FULL LENGTH SIZING DIES ONLY, .243 WINCHESTER FULL LENGTH SIZING DIE ONLY -tuote on suunniteltu säätämään patruunan koko koko pituudeltaan, ei vain kaulasta. Tämä tekee siitä erinomaisen valinnan kaikille kivääreille, jotka käyttävät samaa patruunaa.
Tuotteen kuvaus
Kun ammut patruunan, messinkikotelo laajenee sopiakseen kiväärisi patruunapesään. Ampumisen jälkeen kotelo supistuu hieman, mutta se ei välttämättä palaa alkuperäisiin mittoihinsa. Täydellinen koon säätämisdies palauttaa kotelon oikeisiin mittoihin säätämällä sekä kaulan että rungon kokoa. Se poistaa myös kaikki ampumisen aikana syntyneet pullistumat tai epäsäännöllisyydet.
Asennusohjeet
- Puhdista ammuttujen koteloiden ulkopinta alkoholilla ja liinalla.
- Zeroaa kalibrit käyttäen headspace comparatoria ja ammuttua koteloa.
- Asenna täydellinen koon säätämisdies ja säädä sitä vähitellen, kunnes kotelon hartia on siirretty taaksepäin 0.001 tuumaa.
- Lukitse die ja voitele kotelot ennen niiden säätämistä.
- Tarkista hartian siirto noin 10 kotelon välein ja säädä die tarvittaessa.
- Vältä messingin liiallista työstämistä estääksesi kotelon pään erottumisen.