Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
H&K VP9/40, P30, HK45 TRIJICON RMR SIGHT MOUNT - Korkealaatuinen ja kestävä kiinnitysratkaisu!
Tervetuloa Brownells Suomeen! Esittelemme ylpeänä EGW:n valmistaman H&K VP9/40, P30 ja HK45 Trijicon RMR Sight Mountin. Tämä kiinnitysratkaisu on suunniteltu erityisesti tarkkuusammuntaan ja se tarjoaa erinomaisen vakauden ja luotettavuuden.
Tuotteen tiedot:
- Materiaali: 7075 Alumiini
- Pinta: Matte Black Hardcoat
- Kokonaispituus: 1.780"
- Kokonaisleveys: 1.1"
- Kiinnitysosat: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
- Red Dot -sovitus: Trijicon RMR, Holosun HS507C
Yhteensopivuus:
Tämä kiinnitys sopii seuraaville malleille:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Tämä kiinnitys ei sovi:
Asennusohjeet:
- Poista takasihteesi*.
- Asenna EGW Sight Mount kiinnityskohteeseen.
- Kiristä set screw (tarvittaessa).
- Aseta red dot -näkölaite EGW Sight Mountiin (pienellä paperipalasella red dot -näkölaite ja kiinnitys väliin helpottaa irrottamista ja pitää Loctiten pois red dot -näkölaiteesta).
- Käytä sinistä Loctitea mukana tulevissa kiinnitysruuveissa.
- Kiristä kiinnitysruuvit 15 in/lbs.
Huom: Mukana tulevat 2 Flat Head Cap Screws -ruuvia on tarkoitettu Trijicon RMR:lle. Ruuvit vaativat 5/64'' allen-avain asennusta varten.