EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount will not work with HK USP.
H&K VP9, P30, HK45, HK45C, VP40 VORTEX VIPER/VENOM SIGHT MOUNT - Laadukas asennusratkaisu
EGW:n punapistekiinnikkeet on suunniteltu asennettavaksi vasemmalta oikealle (mikäli piippu on eteenpäin). Dovetailissa on progressiivinen kapeneva muoto, joka helpottaa asennusta. Poista vain aseesi takasight ja vaihda se EGW-kiinnikkeeseen voidaksesi asentaa Vortex Viper/Venom, Burris FastFire tai Docter punapisteen.
Asennusohjeet
- Poista takasight*
- Asenna EGW Sight Mount dovetailiin
- Kiristä set screw (jos sovellettavissa)
- Aseta punapiste EGW Sight Mountiin (pienet paperipalat punapisteen ja kiinnikkeen väliin helpottavat poistoa ja pitävät Loctiten pois punapisteestä)
- Levitä sinistä Loctitea mukana toimitettuihin asennusruuveihin
- Kiristä asennusruuvit 15 in/lbs
2 Button Head Cap Screws - Mukana Vortex Viper ja Venom Sights -malleille
2 Flat Head Cap Screws - Mukana Burris FastFire ja Docter Sights -malleille
Kiinnikkeen mukana tulevat ruuvit vaativat 5/64'' allen-avain asennusta varten.
Huomio: Aseen muokkaaminen voi mitätöidä valmistajan takuun. Tämä tuote tulee asentaa ja tarkistaa pätevän asekorjaajan toimesta. Valmistaja ei ota vastuuta vahingoista tai vammoista, jotka voivat johtua väärästä asennuksesta tai tuotteen käytöstä. Tämä kiinnike ei toimi HK USP:n kanssa.