FHD FLASH HIDERS These fit the plan B type mounts. This is an updated version that has larger wrench flats on the rear. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
FHD FLASH HIDERS - Innovatiivinen ja tehokas ratkaisu
FHD FLASH HIDERS sopivat Plan B -tyyppisiin kiinnityksiin. Tämä on päivitetty versio, jossa on suuremmat avaimen tasot takana. Käytä aina kohdistustankoa varmistaaksesi, että koko järjestelmä on asetettu oikein. Varmista, että kaikki pinnat on puhdistettu ja että suukappale on kiinnitetty ja Rocksetattu piippuun.
Huomioithan, että Q-tyypin käytössä takuu raukeaa. Kierrä suukappale noin 30 ft lbs:n momenttiin ja varmista, että se on suora olkapäätä vasten. Kun asetat vaimentimen suukappaleen päälle, varmista, että kierteet ja kartiot ovat puhtaat. Kierrä vaimenninta 10 ft lbs:n momenttiin ja varmista kohdistus. Nauti.
Nitride-pinta johtaa tiiviimpään tiivistykseen, joten on äärimmäisen tärkeää kiertää ja Rocksettaa suukappale oikein piippuun.
Ominaisuudet:
- 17-4 PH H900
- Atlas ja Atlas XL yhteensopiva
- Plan B yhteensopiva
- Atlas XL Adapter ilman ylivuotoa
- Musta nitride-pinta (67 HRC pinnan kovuus)
- Shimmejä ei sisällytetä, jos haluat erityisesti ajoittaa tämän, shimmit ovat tarpeen. Huom: piippusi saattaa tarvita shimmin, jos valmistaja ei ole laittanut siihen kierrehuoltoa.