EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. Does not work with Ruger SR9E or Ruger SR22.
EGW:n Sight Mount Vortex Viper/Venomille RUGER SR9, SR40 ja SR45 -kiväärille
EGW:n punapistetähtäimet on suunniteltu asennettavaksi vasemmalta oikealle (muzzle eteenpäin). Dovetailissa on progressiivinen taper, joka helpottaa asennusta. Poista vain aseen takatähtäin ja vaihda se EGW:n mounttiin, jotta voit asentaa Vortex Viper/Venom, Burris FastFire tai Docter punapistetähtäimen. Voit poistaa mountin ja vaihtaa takatähtäimen milloin tahansa. Asennustarvikkeet sisältyvät.
Asennusohjeet
- Poista takatähtäin*
- Asenna EGW Sight Mount dovetailiin
- Kireytä set screw (jos sovellettavissa)
- Aseta punapistetähtäin EGW Sight Mountiin (pienellä paperinpalan asettaminen punapistetähtäimen ja sight mountin väliin helpottaa poistamista ja pitää Loctiten pois punapistetähtäimestä).
- Levitä sinistä Loctitea mukana toimitettuihin asennusruuveihin
- Kiristä asennusruuvit 15in/lbs
2 Button Head Cap Screws - toimitetaan Vortex Viper ja Venom tähtäimille
2 Flat Head Cap Screws - toimitetaan Burris FastFire ja Docter tähtäimille
Mountin mukana tulevat ruuvit vaativat 5/64'' allen avaimen asennusta varten.
Muokkaaminen aseestasi saattaa mitätöidä valmistajan takuun.
Tämä tuote tulisi asentaa ja tarkistaa pätevän asekorjaajan toimesta.
Ei ole vastuuta vahingoista tai vammoista, jotka voivat johtua väärästä asennuksesta tai tuotteen käytöstä.
Ei toimi Ruger SR9E tai Ruger SR22 -mallien kanssa.