Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: Ruger Flattop Revolvers
Vortex Razor -kiinnitysmontti Ruger-revolverille
EGW:n Vortex Razor -kiinnitysmontti on täydellinen ratkaisu Ruger-revolverin omistajille, jotka haluavat asentaa Vortex Razor, C-More RTS tai STS punapisteen. Tämä tuote on helppo asentaa ja poistaa, joten voit vaihdella sightin ja takasightin välillä vaivattomasti.
Asennusohjeet:
- Poista takasight*.
- Asenna EGW Sight Mount pulttikanavaan.
- Tiukkaa asetussiru (jos sovellettavissa).
- Aseta punapistesight EGW Sight Mountiin (pienellä paperinpalan sijoittaminen punapistesightin ja kiinnitysmontin väliin helpottaa poistamista ja pitää Loctiten pois punapistesightista).
- Levitä sinistä Loctitea mukana toimitettuihin kiinnitysruuveihin.
- Kiristä kiinnitysruuvit 15 in/lbs momenttiin.
Huomioithan, että mukana tulevat ruuvit vaativat 5/64'' kuusiokoloavainta asennukseen. Tämä montti ei sovi: