EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Please take note to the Pre 2017 and Post 2017 differences. Pre 2017 rear shelf behind the dovetail is .187"" and Post 2017 is .120".
EGW Sight Mount Vortex Viper/Venom - Helppo asennus Desert Eagle Pre 2017:lle
EGW:n punapisteet on suunniteltu asennettavaksi vasemmalta oikealle (mikäli piippu on eteenpäin). Kouru on muotoiltu asteittain, mikä helpottaa asennusta. Poista yksinkertaisesti aseesi takasivustat ja vaihda se EGW:n kiinnikkeeseen, jotta voit asentaa Vortex Viper/Venom, Burris FastFire tai Docter punapisteen. Muutoksia ei vaadita. Voit poistaa kiinnikkeen ja vaihtaa takasivustasi milloin tahansa. Asennustarvikkeet sisältyvät.
Asennusohjeet
- Poista takasivusta*
- Asenna EGW Sight Mount kouruun
- Tiukkaa asetuskruvia (jos sovellettavissa)
- Aseta punapiste EGW Sight Mountiin (pienellä paperinpalan asettamisella punapisteen ja kiinnikkeen väliin helpotat poistamista ja estät Loctiten pääsemästä punapisteeseen)
- Sovita sinistä Loctitea mukana toimitettuihin asennusruuveihin
- Kiristä asennusruuvit 15in/lbs
Toimitetut ruuvit:
- 2 Button Head Cap Screws - Tarjotaan Vortex Viper ja Venom Sights -malleille
- 2 Flat Head Cap Screws - Tarjotaan Burris FastFire ja Docter Sights -malleille
Huomaa, että tämän kiinnikkeen mukana toimitetut ruuvit vaativat 5/64'' kuusiokoloavainta asennusta varten. Kiinnitä huomiota Pre 2017 ja Post 2017 eroihin. Pre 2017 takahylly kourun takana on .187" ja Post 2017 on .120".