There is a very narrow, (.004") throat diameter range where maximum accuracy is obtained. Go smaller or larger and accuracy will suffer. By simply slipping the Plug Gauge into the barrel throat, it s possible to tell at a glance when you are approaching the correct diameter. Warns you before you go too far. Also valuable as a diagnostic tool for guns brought in with accuracy complaints, (designed for chamfers cut with our tools - may not give a correct reading on guns with other degrees of chamfer). Each gauge is self-piloted, precision-ground, hardened and stepped to show minimum and maximum optimum diameters. 11° and 18° Gauge measures both chamfer angles. Sizes .22RF; .32; .38/.357; .38-40/.40; .41; .44; .45. 5° Ruger-Style Gauge available in .38/.357, .44 and .45 caliber only.
SPECS: 1¼" (3.2cm) long. Steel. Instructions included. 11°-18° gauges measure forcing cones with either angle. 5°, .38/.357 gauge is designed for Ruger .38/.357 s which began using this angle about 1983. Complete Set includes the Rimfire Gauge, all ten Centerfire Gauges and Instructions in a Bench Kit Box.
Tarkkuuden ja tulosten maksimoimiseksi pistooleiden chamferointityökalujen avulla
BARREL CHAMFERING PLUG GAUGES, 11°-18° 10MM/40 CALIBER BARREL CHAMFERING PLUG GAUGE ONLY on suunniteltu tarjoamaan maksimaalista tarkkuutta ja tuloksia. On olemassa erittäin kapea, (.004") kurkkuhalkaisijaltaan, jossa maksimaalinen tarkkuus saavutetaan. Jos mennään pienemmäksi tai suuremmaksi, tarkkuus kärsii.
Liittämällä Plug Gauge aseen piippuun, on mahdollista nähdä yhdellä silmäyksellä, kun lähestyt oikeaa halkaisijaa. Se varoittaa ennen kuin menee liian pitkälle. Tämä työkalu on myös arvokas diagnostiikkatyökalu aseille, jotka tuodaan tarkkuusvalitusten kanssa (suunniteltu chamferille, jotka on leikattu meidän työkaluillamme - ei välttämättä anna oikeaa lukemaa aseille, joissa on muita chamfer-asteita).
Tuotteen tiedot
- Pituus: 1¼" (3.2 cm)
- Materiaali: Teräs
- Käyttöohjeet: Mukana
- Gauge-asteet: 11°-18° mittaavat pakotuskartioita kummallakin kulmalla
- 5°, .38/.357 gauge: Suunniteltu Ruger .38/.357 aseille, jotka alkoivat käyttää tätä kulmaa noin vuonna 1983
Täydellinen setti sisältää Rimfire Gauge n, kaikki kymmenen Centerfire Gauge a ja ohjeet Bench Kit Box issa.