Ominaisuudet
- Määrä: 6
- Toimituksen paino: 0,023kg
- Toimituksen korkeus: 43mm
- Toimituksen leveys: 89mm
- Toimituksen pituus: 173mm
- UPC: 723189000561
Tuotenro: 155000211
Valm.nro: 56
723189000561 Snap capit ovat loistavia kuivaharjoitteluun, koska ne antavat sinun keskittyä aseen vakaana pitämiseen liipaisimen vetämisen aikana, mikä auttaa vähentämään pelkoa oikean ammuksen käytön aikana. Kestävä alumiininen Rimfire snap cap suojaa lukon pintaa ja kestää satoja "laukaisuja".Toimitusaika noin 2-4 viikkoa.
Snap capit ovat erinomaisia kuivaharjoitteluun, sillä ne auttavat sinua keskittymään aseen vakaana pitämiseen liipaisimen vetämisen aikana. Tämä auttaa vähentämään laukaisujännitystä elävän ammuksen käytön yhteydessä. Kestävä alumiininen Rimfire snap cap suojaa luodin aukkoa ja kestää satoja "laukauksia".
BOO! 20.2.2015
I am a a gunsmith. I don't want holes in my walls (or me) when I work on 22's. I bought these SPECIFICALLY for action proving, feeding, dry fire. The FIRST time I used them was great, cycled through the feeding tube, ejected (yay, I fixed it). The SECOND time, no go. (Here is where you learn from my experience). Feeding issues. They "disappeared". They were stuck in the feeding tube and the spring wouldn't push them past the little bump inside. Oh, old, weak spring, stretched it little, nope. Well, this guy never cleaned his gun, maybe it is gunked up, disassembled the entire feeding mechanism, cleaned, lightly buffed appropriate areas, nope. They are getting stuck near the elbow of the feeding tube. Checked the set screw to be sure it wasn't protruding, nope. Is the elbow bent or damaged, nope... couple hours after starting this quest I discovered that the dummy rounds rims were deformed just enough (from the dry fire that they were bought for) that they no longer would go through the elbow... tried several new live rounds and viola, they flew through like the had somewhere to be... GRR!
Works as expected 22.1.2013
Since you can't spring-load a rimfire snap cap, these work just fine. Yes, the firing pin leaves a dent, turn the cap a bit and try again until the rim is fully dented. I believe it is still effective even though the rim of the cap is fully dented. The point is to prevent denting the barrel edge and these do that just fine.
Of course, you can also use a fired .22 case for the same effect. It's just harder to chamber.
Kohdattiin virhe tämän sisällön lataamisessa. Päivitä sivu jatkaaksesi. Jos ongelma jatkuu, ota yhteyttä asiakaspalveluumme.