Ominaisuudet
- Asetyyppi:
1911
- Malli:
Commander
,Government
- Toimituksen paino: 0,014kg
- Toimituksen leveys: 83mm
- Toimituksen pituus: 146mm
Tuotenro: 168000127
Valm.nro: P28SC
Kattava setti 11 tarkkuushiottua pulttia ja pumppua olemassa olevan 1911:n kunnostamiseen tai uuden rakentamiseen alusta alkaen. Lämpökäsitelty erinomaisen pinnan kulutuskestävyyden takaamiseksi pitkän käyttöiän saavuttamiseksi. Saatavana mattasinistetystä hiiliteräksestä tai luonnollisesti viimeistellystä ruostumattomasta teräksestä.Toimitusaika noin 2-4 viikkoa.
CASPIANin 1911 PIN SET on täydellinen ratkaisu, joka korvittaa kaikki pinni- ja plungeriosat pistooleissa. Tämä sarja on suunniteltu sekä olemassa olevan 1911:n kunnostamiseen että uuden rakentamiseen alusta alkaen.
Setti sisältää 11 tarkkuusjyrsittyä pinniä ja plungeria, jotka on lämpökäsitelty erinomaisen pinnan kulutuskestävyyden takaamiseksi pitkän käyttöiän saavuttamiseksi. Saatavilla on matta blued hiiliteräksestä tai luonnollisesta ruostumattomasta teräksestä.
1911
Commander,
Government
Buyer Beware 27.12.2011
I bought this set of pins to finish out a 1911 build I'm doing for my wife. I ordered the Caspian Race Ready Receiver (168-100-110) for the build, so I figured I'd order this pin set since it's made by the same manufacturer. The ejector pin in this set is solid, and I think it's slightly oversize, as it bent while I was trying to install it into the ejector pin hole (yes, I had done the requisite notching of the ejector post, and there was no blocking of the hole when I looked thru it; I also should have measured the diameter of the pin against the diameter of the hole--I really think a roll pin is better for this application).
Additionally, if you decide to use the Cylinder and Slide Professional Trigger Kit (206-000-019), the hammer strut pin in this set is too large (the pin is .095 and the hole in the hammer is about .093). I reamed out the hole in the hammer, but it was still a very hard pin to drive in.
In the future, I will probably order a different set of pins. I may or may not order Caspian pins again, I haven't yet decided. The mainspring parts are all fine, as are the plunger pins and the sear and hammer pins.
I want to caveat the "Would you recommend this to a friend" question by saying I would recommend it, but I would also tell them what I experienced.
Kohdattiin virhe tämän sisällön lataamisessa. Päivitä sivu jatkaaksesi. Jos ongelma jatkuu, ota yhteyttä asiakaspalveluumme.