Brownells Finland - Laajin valikoima aseen osia, lippaita, ammuntatarvikkeita, asesepän työkaluja ja optiikkaa Suomi

EGW
H&K VP9, P30, HK45, VP40 LEUPOLD DELTAPOINT PRO SIGHT MOUNT

841370114221 296000683
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount is not intended for use with the optics ready version of these pistols. This mount does not fit: HK USP
84.9 84.9 1 EUR
Tuotenro: 296000683
EGW H&K VP9, P30, HK45, VP40 LEUPOLD DELTAPOINT PRO SIGHT MNT
Valmistajan tuotenumero: 49408 841370114221 EGW:n punapistetähtäimet on tarkoitettu asennettaviksi vasemmalta oikealle (piipun ollessa eteenpäin suunnattuna). Urassa on progressiivinen kavennus helpottamaan asennusta. Poista vain aseen takatähtäin ja korvaa se EGW:n kiinnikkeellä, jotta voit asentaa Leupold DeltaPoint Pro, JPoint, Redfield Accelerator tai Optima punapistetähtäimen. Voit milloin tahansa poistaa kiinnikkeen ja palauttaa takatähtäimen. Asennustarvikkeet sisältyvät. Asennusohjeet: Poista takatähtäin* Asenna EGW:n tähtäinkisko uraan Kiristä asetuspultti (jos sovellettavissa) Aseta punapistetähtäin EGW:n tähtäinkiskoon (punapistetähtäimen ja kiskon väliin asetettu pieni paperinpala helpottaa poistamista ja pitää Loctiten poissa punapistetähtäimestä.) Levitä sinistä Loctitea mukana tuleviin kiinnitysruuveihin Kiristä kiinnitysruuvit momenttiin 15in/lbs Aseen muokkaaminen voi mitätöidä valmistajan takuun. Tämän tuotteen tulisi asentaa ja tarkistaa pätevä aseaseppä. Vastuuvapauslauseke: Valmistaja ei ota mitään vastuuta mahdollisista vahingoista tai vammoista, jotka johtuvat tämän tuotteen virheellisestä asennuksesta tai käytöstä. Tämä kiinnike ei ole tarkoitettu näiden pistoolien optiikkavalmiisiin versioihin. Tämä kiinnike ei sovi: HK USP.
84.9 EUR 0 84,90 € *
Ilmoita saatavuudesta
Ei saatavilla.
Ominaisuudet: Jalustojen lukumäärä: 1-Piece Malli: P30, 45, VP9, P30L, 45C, VP40, VP9SK, P30sk Materiaali: Aluminum Merkki: Heckler & Koch Tyyppi: Tactical Väri: Black

Ominaisuudet

Jalustojen lukumäärä: 1-Piece Malli: P30L,45,P30,45C,VP9SK,VP9,VP40,P30sk Materiaali: Aluminum Tyyli: Tactical Valmistaja: Heckler & Koch Väri: Black Toimituksen paino: 0,045kg Toimituksen korkeus: 25mm Toimituksen leveys: 76mm Toimituksen pituus: 140mm

Tuotekuvaus

Made in USA



EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount is not intended for use with the optics ready version of these pistols. This mount does not fit: HK USP
Uutiskirje